Controllers must be running the same version of firmware as the Designer software. Controllers with incompatible firmware will be highlighted in red. Select the Controller in Network Mode and press Reload Firmware.Read more
Controllers must be running the same version of firmware as the Designer software. Controllers with incompatible firmware will be highlighted in red. Select the Controller in Network Mode and press Reload Firmware.Read more
Controllers must be on the same Ethernet subnet as the PC running Designer. Select the controller and change its IP settings accordingly.Read more
Presuming that the Controller has successfully booted its firmware (thus its Active LED illuminated) then there is a communication problem between the Controller and the PC running Designer: Ethernet Problems (Network) Quit and restart Designer again once you’re sure that the network is up, use your PC’s LAN status tools. By default, the Controllers areRead more
LPC Status LEDs The Pharos logo will illuminate when power is applied to the Controller. The red LEDs on the top/front of the Controller indicate the unit’s current status: The Active LED illuminates once the boot-up procedure has completed and is indicative of a fully functional unit. The Ethernet LED(s) indicates network activity (not networkRead more
Pharos Architectural Controls Limited
International House
7 High Street
Ealing Broadway
London W5 5DB
United Kingdom
+44 (0)20 7471 9449