Custom web interfaces offer end users a useful device-based override control solution. Prior to 2.8.0, triggering web API (JavaScript/HTTP) commands via a custom web interface would only affect the controller on which it was fired. For projects with multiple controllers, which all needed to respond to a web UI command, this necessitated many additional triggersRead more
Blog
sACN Sync is a new feature that aligns with the specification for the sACN protocol. It works in a similar vein to ArtSync or KiNET Sync, although there is a keen difference that will be covered in this introduction to the new feature. But, firstly, why would you need to use sACN Sync? When youRead more
With the cost of LEDs becoming incredibly low over the past few years, new protocols were developed to drive large numbers of LEDs easily; the SDI was designed to convert our current DMX functionality into an ability to speak these new protocols. This is where serial data comes in; by this, we mean two types;Read more
With our continuous development of Designer software, we have upgraded a few of the capabilities of the VLC family Controllers. From 2.8.0, the following changes/additions have been made: White space management; allowing a content target multiplier to scale content on arrays where there is a lot of physical space between pixels Support for 60Hz ImprovementsRead more
NOTE: the method described below for EDNs also applies to KiNET Power Supplies. The EDN is our new Ethernet Data Node, capable of distributing up to 20 ports of DMX from a Pharos networked control system. As well as a single Controller, such as an LPC 20, sending its output to all the portsRead more
For fixtures that have more emitters than just RGB, we have always intelligently mixed colours using our internal “Virtual RGB” playback engine algorithm, converting a given RGB colour to RGBA, RGBW, etc, by extrapolating the additional values based on relevant emitter levels. However, the calculated level for White or Amber was not always the desiredRead more
Naturalis Biodiversity Center in Leiden is the Netherlands’ national research institute for biodiversity. In late 2019 Naturalis expanded to a stunning new building to enable it to welcome greater numbers of visitors and scientists alike, as well as housing every department of the institute in one place. The entire building was designed with sustainability inRead more
In 2013, Redcar Beacon opened its doors as part of a £75m redevelopment of the Redcar seafront. Offering visitors the chance to enjoy a 360-degree view, the vertical pier is the town’s tallest structure standing at 80ft high. Redcar Beacon is spread over seven floors, housing office space, a radio station, a café, and theRead more
In this Tips and Tricks, we’re going to look over the Triggers view to cover the generic properties that all Triggers share. Firstly, select or create a new Trigger, as shown below. Each trigger is assigned the next available Number for reference as it is created. Trigger numbering is not essential, as the controllersRead more
Many jobs require lights to be active at the same time as an announcement or music. When your project is completed, and everything is all hooked up to Timecode, you want to make sure that your lighting doesn’t miss its cue. There are two features to help sync your lights and sound: Simulation Audio (availableRead more
