RDM
The Pharos Designer RDM is a four-port DMX512 repeater / splitter compatible with the RDM standard to provide DMX output distribution to luminaires and other devices.
Optically isolated splitting
DMX splitters are an essential requirement for most control systems, allowing multiple separate cable runs from a single DMX output and ensuring electrical isolation. The RDM is provided in a rugged DIN rail enclosure with install-friendly connectors.
The RDM features a fully opto-isolated input with a through port for daisy-chaining DMX signals
Supports reporting and configuration through the DMX RDM protocol
Plug and play functionality – simply connect the RDM to any physical DMX source, and have that data repeated on all four outputs
Features
Four Outputs
Repeats a DMX signal to 4 outputs, each allowing for 32 DMX devices to be connected.
RDM
Supports the Remote Device Management protocol (ANSI E1.20) allowing devices connected to any of the four outputs to communicate back to a Pharos Designer controller over the DMX link.
Isolated
Opto-isolated input and through connection for daisy-chaining the DMX connection.
Reliable
Designed and manufactured in the UK, the RDM is a rugged, compact 6 unit wide device. The solid-state design ensures unparalleled reliability.
Installer Friendly
Made for permanent installation, with installer-friendly 0.200” (5.08mm) plug-in rising clamp terminals, a rugged, compact enclosure, and easy DIN-rail mounting.
Scalable
Each RDM can be daisy-chained, allowing a single source to control a wide network of DMX fixtures.
5 Year Warranty
The Pharos Designer RDM, as well as all Pharos devices, comes with a 5 year warranty.
TECHNICAL INFORMATION & DOWNLOADS
RDM Datasheet
Click on the link below to download the datasheet.
Download Software
Download the latest version of our Designer software.
Comparison Chart
See and compare features and specs of all our products.
Interfaces
DMX/RDM input
DMX512 port, RDM compatible *
DMX/RDM thru
DMX512 port, RDM compatible *
DMX/RDM outputs
Four DMX512 ports, RDM compatible *
* Install-friendly 0.200″ (5.08mm) plug in rising clamp connectors (included)
Specifications
Certifications
CE compliant, UKCA compliant, ETL/cETL listed
Power
9-48V DC *, 4W typical
Temperature
0°C to 50°C (32°F to 122°F)
Humidity
10-50% relative, non-condensing
Ingress
IP40
Physical
6 unit wide DIN rail mounting enclosure (DIN43880 / EN60715 (35/7.5 rail))
10.8 x 9 x 5.8 cm (4.2 x 3.5 x 2.3 in)
0.5 kg (1.1 lbs)
Shipping
20 x 15 x 12 cm (8 x 6 x 5 in)
0.7 kg (1.6 lbs)
* Install-friendly 0.200″ (5.08mm) plug in rising clamp connectors (included)